#Multiviewer ver 2.0 download simulator#
PDS-4K: The GUI's simulator tab can now change the base model as well as allow the DP1.2 and Audio card to be simulated.EM: Added a "Switch Operator" button to the top left corner of the GUI.EM: Presets and External Devices and commands can be renamed on the Cue Menu page.EM: An input's PGM Tally State will change as soon as the Input begins to transition to PGM.PDS-4K: Added Auto System Setup to the GUI.PDS-4K: Added HDR and Wide Color Gamut support.Luma and Chroma Key capability is now available on single layers. PDS-4K: Added support new DisplayPort Input and Audio (plus Dante) processing card.IP4K: Added the "Non-Compliant Device" control to the Front Panel EDID menus on DP1.2 inputs.EC: Added Syntax for Backup and Primary Input(s) control.EM: Tooltip for Destination Names shows name of Destination that may have become truncated.EM: Added a GUI layer "Transparent Mode" control to enable the user to see layers lower in the z-order while keeping the content visible in the GUI.EM: Added a way to sort linked Chassis in the workspace by unit ID in ascending or descending order.EC-210: It is not possible to setup a Class B subnet on the EC-210 controller.EC-210: Sometimes when an external display is plugged in after the EC-210 has booted, one or more of the screens may show grey.EC-210: Left Monitor Grey: Certain conditions may cause the left monitor to start with the "External Input" check box turned on, even when there is no input device attached.PDS-4K: Audio Option Card: When running the Dante Card in Redundant Ethernet mode, the IP Address information for the Secondary Ethernet Conenctor (#2) that shows on the Front Panel and the GUI will be incorrect.PDS-4K: HDMI 1.4 devices that output UHD at 50/59.94/60 with 4:2:0 chroma sub-sampling may not be acquired.
EM: There is a known issue with Atomos Shogun not creating valid CRC streams per SMPTE ST-2081/2082 at 6/12G-SDI rates and as such the Tri-Combo Input does not acquire its signal.EM: Due to certain LAN configurations, it is possible that backup operations can succeed but restore operations can fail from the web app.EM: There is no intended use for enabling the DisplayID Block for use with single connector inputs/backgrounds and if enabled with such may cause the input to stop displaying picture until the chassis is soft reset (power cycled).It can only be installed after the firmware has been upgraded to at least 7.0. Please note: OS of E2/S3/EX/ImagePRO-4K is now the same.E2/S3/EX/ImagePRO-4K Operating System: em_update_os.3.1.1.tar.gz.E2/S3/EX/ImagePRO-4K Firmware: em_update_vp.9.0. or higher.PDS-4K Firmware: pds_update_vp.enc.9.0. or higher.Use the following with this release of EM firmware.
Event Master Toolset Version 9.0 Build 65399 Please read the What's New file after downloading this bundle for more detailed information about these features.
0 kommentar(er)
